Who roll's fenders (properly)

[Macindude]

Anyone here have a fender roller? I've pretty much butchered my front fenders trying to get them to clear the tires back when I had et20 up front, now it's et25.

Now I need to get the rear ones done and I'd prefer not to mess them up (was running et35 in back now it's 25 like the front).

Thanks In Advance!

[sh!tluck]

I'm not sure about the Ames crew, but there are a few guys around the Dubuque/CR area, both are quite the drive for you though

[Macindude]

That's not too terribly far away, I come to cedar falls for drag racing sometimes (like probably tomorrow night) that's most of the way to Dubuque (isn't it?).

The car's driveable, rubs a little on the sidewalls, but I wanna run 225's on my current wheels (205's on now) and my fifteens are +2 (which will put them 23 mm further out (although those have 195's, which comes to 18mm) LOL.

[Macindude]

lol, just realized I put parentheses iniside parentheses.

[bigrobsa]

That's YOU I see at CFR?

Nice.

Sorry for the hijack. :D

[65dunebuggy]

Joe at DPI in Dubuque can do them

[sh!tluck]

I think Cedar Rapids would be closer, Cedar Falls about an hour and 15 minutes from Dubuque whereas Cedar Rapids is only like 45 minutes from Cedar Falls. I think Casey (OrangeDub) or Ryan (dudepal) have one.

[Macindude]

I shall have to contact one (or both... damn do I love parentheses) of those fine fellows.

[Jameson250s]

You have seen me at Cfr too

[Macindude]

You have seen me at Cfr too

I think I remember you... Dark blue jetta, we staged together once?